How do Traffic Signals Work (2019)

The two-adjacent signals causing extra traffic is something I encounter daily in Berkeley -- Ashby / Claremont & Ashby / Domingo. I probably blow an average of 5 minutes a day cause of that double intersection.

To highlight one other point from the video: You want a light to be able to clear the line built up each time. If not, flux in > flux out and that's a recipe for a growing line, which causes a traffic jam.

> Actuated signal control [...] inductive loop sensors embedded into the road surface

It blows my mind how many people don't realize that's what those circles near the stop bar of an intersection are for, and will then stop 3+ car lengths behind the stop bar, and then can't figure out why the light is never going green.

> two signals closely spaced in a row on a major roadway. If one signal gives a green but the next one doesn’t, cars can back up

This is a major problem at an intersection near me that I used to have to drive through frequently. Two intersections, only about 500 feet between them, and MOST traffic during rush out coming from just one of the directions, yet the lights were often exactly out of sync. The first light would be red while the next one was green. Then the first would go green while the other went red, and traffic would only move about 500 feet then stop for 2 minutes. The backup would last well over a mile.

> The obvious next step in efficiency is coordination of most or all the signals within a traffic network. This is the job of adaptive signal control technologies, or ASCT. [..] These types of systems can dramatically reduce congestion

My cynical ass would not be surprised at all if oil/gas companies were lobbying against ASCT because idling cars are buying more fuel. Wouldn't be too hard to convince people that an ASCT would cost too much to implement while not producing significant traffic benefits.

What I find most interesting about the computer side of traffic signal controllers is the interlock design needed to prevent a glitch or memory fault from activating conflicting phases at once, eg two intersecting approaches getting green simultaneously. That's about as safety-critical as it gets for a piece of everyday infrastructure. Would've liked to see more depth on that, though I imagine the specifics are controller/vendor-specific.

I think that interlock design also goes some way toward mitigating the security risks ASCT systems would otherwise pose, as mentioned in the article. On any decent controller, even the control room shouldn't be able to deliberately trigger conflicting phases.